
Troubleshooting
from my iPunch 2 speaker
• Make sure the power cord is properly connected to the back
of the iPunch 2 system and that the system is plugged into
the AC power outlet.
• Ensure the Source / Mode “M” button is set correctly.
• Press the Play/Pause button on the unit and on the remote
control.
• Increase the system volume.
• Increase the volume on your connected device
• Remove your iPod/iPhone from the dock, wait 5 seconds,
then reconnect it.
• Unplug the power cable for 1 minute, and then reconnect it.
• If using a Lightning Adapter: make sure that you are using
an official adapter. The adapter must contain a decoding
chip in order to play music.
charging
• Make sure the power cord is properly connected on the back
of the unit.
• Make sure the system is plugged into a live AC outlet.
• Undock and Re-dock the iPod/iPhone to ensure that it is
properly connected
• Finally, ensure that your iPod/iPhone is working and charges
normally from its normal charging cable.
speaker via Bluetooth
• Long press the pause/play button to start Pair Mode and
reconnect
• Move the music playing device closer to the iPunch 2
are found
• Ensure the audio cable (which acts as an antennae) is
attached
• Move the antennae to improve reception
• Finally, move the Speaker system to a more favourable
respond with the remote
control
• Ensure that the plastic strip has been removed in order that
the battery is working.
• Make sure the path between the remote and the system is
unobstructed.
• Remove your iPod/iPhone from the dock, wait 5 seconds,
then reconnect it.
• Turn the battery around
• Change the battery
My system does not
respond to any controls
• Unplug the power cable for 1 minute. Plug it back into the
iPunch 2 to reset the system.
Komentarze do niniejszej Instrukcji